Theoretically it is possible to flash Nokia Phones also with the Makinterface / MAKInterface Pro. The problem is that no flashing software for the serial port, which is beeing used by the MAKInterface / MAKInterface Pro, has been developed yet.
For that reason we have developed the "Nokia Flasher Interface". It is a standalone interface, which has to be connected to the parallel port and uses the same cables, we are offering as FBUS/MBUS cables for the Makinterface / MAKInterface Pro.
The Interface is connected to the parallel port. On the other side is a 2*5=10 pole connector. This connector is pinout compatible with our Nokia Cables (except the Nokia 3210)
So you can use our cables with the Makinterface / MAKInterface Pro as FBUS and MBUS cables, and also with the Nokia flasher for flashing Nokia Phones (5xxx/6xxx/7xxx, 3110/8110).
The cables that we will offer in the future, for the Nokia 3310, 8210, ... will also be compatible with the Nokia Flasher, besides FBUS and MBUS mode with the Makinterface / MAKInterface Pro.
Only the Nokia 3210 requires besides "FBUS RX, FBUS TX, MBUS, GND" also the VPP line. Our FBUS/MBUS cable has only the 4 lines "FBUS RX, FBUS TX, MBUS, GND". The flasher interface was succesfuly tested with a Nokia 3210 with a modifyed cable, were a additional wire has to be soldered to the VPP line, according the connection description an this page.
In the attachment are the pinouts for various Nokia Phones, with the connection diagrams how they should be connected to the Nokia Flasher. These cables are also FBUS comptible with the MAKInterface / MAKInterface Pro.