SC8in1 - Installation Procedure for Nokia dbox2



SC8in1 is placed in the Nokia dbox2 instead of the modem. After opening the housing, the modem is removed and the SC8in1 inserted instead.

Nokia dbox2 with modem

Nokia dbox2 with removed modem



Nokia dbox2 with inserted SC8in1

The pin rows of the second smartcard-unit have to be cut and removed. The pin rows can be removed by heating them up with a soldering device and pulling out. The first two pins of the lower PCB have to be left approximately 5mm long.

Pin rows, which have to be cut

The first two pins of the lower PCB have to be left approx. 5 mm long



The 10pole pin row has to be soldered on the upper PCB. The first two pins of the lower PCB, which have been left with height of approx. 5mm, have to be connected with a jumper. Afterwards the soldered pin row has to be connected with the pin row of SC8in1.

Jumper on the two pins of the lower PCB

Connection to SC8in1